Kurth Electronic KE801, Blå, Signalstyrke, 9 V, 80 g, 220 x 40 x 25 mm

The KE801 Kit (EasyTest KE800/PROBE KE410) improves speed and confidence in the installation and maintenance of multimedia communications cabling.\n\nEasyTest KE800 can transmit either three continous tones (Solid) or three alternating tones (Alt). In function Continuity it is possible to check for shorts or opens up to 40 kOhm, visible by a green LED and audible by a resistance depending tone. The EasyTest KE800 is able to send the tone into live telephone lines without disturbing services (tone will still be audible). Over voltage protection is in any mode up to 500 V AC. EasyTest KE800 provides solid Alligator Clips and special RJ11 and RJ45 plugs with strain relief and PIN 1 + 8 protection slots. If the RJ45 plug is inserted into an active LAN jack in the DATA mode, the DATA LED will pulse brightly, and the associated link activity light on the conventional LAN hub or switch will begin to blink. In the CONT position EasyTest leads and RJ11 plug will indicate short circuits (zero ohms to 100KOhm).\n\nThe capacitive PROBE410 is high sensitive and is working from EasyTest KE300 or any other tone generator to identify and trace wires or cables. The double, HIGH and LOW volume switch made of high dust and moisture resistant mylar membrane allows fast and easy operation.\nThe PROBE410 detects a cable from a distance of up to 100 cm (33"). The nearly unbreakable tip made of carbon fiber prevents shorts or disturbance of telephone or data lines and is field replaceable. The slender design allows high precision tracing of pairs, even in bundles or 110 / KRONE blocks. The PROBE has additionaly a filtered green signal strength LED. This LED lights only up if there is the signal from the TONER detected. All unwanted noise and power hum is not shown. The bright white LED replaces the need for a torch light in dark distribution boxes. Even there are the colors of the wires perfect to identify.\n\nEasyTest KE800 contains an high power Fiber Optic Fault Locator.\nIt is easy to use and provides a universal jack for the most connectors with a 2.5 mm Ferrule. It can be used to check singlemode / multimode optical fibers and other fiber optic components on faults. In the Laser Mode modulated, audible frequency from 270 Hz and 1 kHz in either Continous Wave or Pulse Mode are adjustable. Using a power meter with demodulation feature on the far end to detect the modulated light, the used frequency will be visible in the display.\n\nThe Kit comes with a solid belt pouch with enough space for EasyTest / PROBE410 as well as the earpiece and the user manual.