TESA 77902-00000, Inne & Ute, Universalkrok, Beige, Limstrimmel, 2,5 kg, Murstein

Adhesive Screw Rectangular for Brick & Stone 2.5kg\ntesa® Adhesive Screw Rectangular for Brick & Stone with the patented nie wieder bohren. Technology is ideally suited for mounting objects on rough and solid surfaces indoors or outside with a secure hold of up to 2.5 kg per screw – use multiple screws for heavier objects. Their slim form allows them to remain concealed behind even narrow objects like cable hooks or shelf brackets. They’re simple to mount and there are no additional tools required; everything you need is in the pack. Just apply the screw, inject the adhesive, let it set and get hanging. The Adhesive Screw is removable, too.\n\n- For rough and solid surfaces like brick & stone\n- Holds up to 2.5kg per screw or 5kg using 2 screws\n- Extra slim to hide behind narrow objects\n- Removable from firm surfaces\n- Suitable for indoor and outdoor use\n\nThe tesa® Adhesive Screw Rectangular for Brick & Stone with patented nie wieder bohren. Technology is designed to support up to 2.5 kg per screw on rough and solid surfaces like brickwork and stone. You can use multiple screws to increase the holding power. Their slim form allows them to remain concealed behind even narrow objects like cable hooks or shelf brackets. They’re simple to mount and there are no additional tools required\n\n\nHow to apply – Step by step\n- Use a brush to get rid of as much grit or dust as you can from the surface to secure an optimal bond.\n- Peel off the protective foil from the adhesive foam tape and lightly press the adhesive screw to the surface. The foam tape is only used to keep the screw in place while you apply the adhesive. Make sure the screw head is aligned so that the body of the Adhesive Screw will be hidden behind your object.\n- Pierce the nozzle on the tube of adhesive and pop the key over the other end.\n- Squeeze the adhesive into the bigger hole in the screw body by giving the key a twist. Continue until the adhesive begins to come out of the smaller hole and the cavity is filled evenly. Allow 12 hours for the adhesive to dry before you put weight on it.\n\nWall-mount just about anything on rough surfaces without a drill\nIt’s always been a kind of a challenge to get screws into surfaces like brickwork and stone. You had to buy or borrow a drill - and specialised masonry drill bits – and make a lot of noise and mess. With a tesa® Adhesive Screw Rectangular for Brick & Stone 2.5 kg, you can mount anything up to 2.5 kg per screw – or 5 kg using two of them – inside or outside without the need for any additional tools. Thanks to their slim shape, these screws can be hidden even behind very narrow objects and won’t be seen once the object is on the wall\n\nSuper simple to use – even easier to remove\nTo remove the screw, get a firm hold on it with a wrench and gently and slowly twist it until the screw becomes loose, then simply remove it from the wall. Residue can be removed with a glass scraper or a metal brush. Please be aware that the tesa® Adhesive Screws are removable from solid surfaces. If used on sensitive surfaces like plaster, the surface may be damaged.\n\nPlease use the Product Finder if you want to mount objects on other surfaces like glass, wallpaper, plaster or tiles and browse our other tesa® Smart Mounting Solutions.\nNot suitable for any non-stick materials.